free stats
Download Print this page
Sealey GA70.V2 Quick Start Manual

Sealey GA70.V2 Quick Start Manual

Four-wheel laser wheel aligner

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear protective
instructions
gloves
1. SAFETY
1.1
GENERAL SAFETY
W ARNING! Ensure Health & Safety, local authority, and general
workshop practice regulations are adhered to when using this
equipment.
M aintain the wheel aligner in good condition (use an authorised
9
service agent).
R eplace or repair damaged parts. Use genuine parts only.
9
Non-authorised parts may be dangerous and will invalidate the
warranty.
L ocate wheel aligner in a suitable working area, keep area clean
9
and tidy and free from unrelated materials.
W ARNING! Use aligner on vehicles that are parked on level and
solid ground.
K eep the gauge clean to ensure accurate performance.
9
D O NOT use outside in damp or wet weather conditions.
‰ 8
D O NOT allow untrained persons to operate the aligner.
‰ 8
D O NOT leave the aligner unattended.
‰ 8
W ARNING! When setting front end alignment on commercial
vehicles never make adjustments to drop arms or interconnecting
links. Doing so could result in serious tyre, wheel and steering
problems.
W ARNING! The warnings, cautions and instructions contained within this
document cannot cover all possible conditions and situations that may occur. It
must be understood that common sense and caution are factors which cannot be
built into this product, but must be applied by the operator.
A ny alignment changes deemed necessary as a result of using this equipment
9
must be made strictly in accordance with the vehicle manufacturer's
recommendations.
1.2
LASER SAFETY
The GA70 utilises a Class II laser that emits low levels of visible radiation (i.e.
wavelengths between 400 and 700 nanometres) which are safe for the skin but
not inherently safe for the eyes. The Class II emission limit is set at the
maximum level for which eye protection is normally afforded by natural aversion
responses to bright light. Accidental eye exposure is therefore normally safe,
although the natural aversion response can be overridden by deliberately staring
into the beam, and can also be influenced by the use of alcohol or drugs.
W ARNING!‰DO NOT look or stare into the laser beam as permanent eye
damage could result.
D O NOT direct the laser beam at any person's (or animal's) eyes as eye damage
‰ 8
could result. If the beam is obstructed by a person during use, release the
contact switch immediately.
D O NOT use the equipment while under the influence of alcohol, drugs or whilst
‰ 8
on medication.
B e aware that reflections of the laser beam from mirrors or other shiny surfaces
9
can be as hazardous as direct eye exposure.
2. INTRODUCTION
Fast, simple and accurate alignment of both front and rear wheels. Optimises vehicle
performance and set up after installation or modification of steering and suspension
components. Simple and fast to use, it is ideal for the busy professional workshop
and has a fast return on investment - potentially adding value to every steering or
suspension job. This fully portable kit is also ideal for track-day set up for the enthusiast.
Works on practically all cars and light commercials with rim diameters between
330mm(13") and 560mm(22"). Supplied with steering wheel clamp, wheel turn plates
and wheeled storage rack and comprehensive operating instructions.
© Jack Sealey Limited
FOUR-WHEEL LASER WHEEL ALIGNER
GA70.V2
MODEL NO:
Wear safety
Wear protective
footwear
clothing
Original Language Version
Keep in dry area
Warning
protect from rain
laser beam
The GA70.V4 kit consists of: Mobile storage unit (see below)
1. Laser Measuring Head
2. Alignment Assembly Flags
3. Steering Wheel Clamp
X2
4. Dished Turning Plate
X2
5. Extension Bobbins
X1
6. 13" Wheel Spacers
GA70.V2 | Issue 2 06/06/2019
X2
X6
X4

Advertisement

loading

Summary of Contents for Sealey GA70.V2

  • Page 1 GA70.V2 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 Model No: ......GA70.V2 Minimum Rim Diameter ....330mm Maximum Rim Diameter.
  • Page 3 6.1.4. The lasers should be calibrated on a yearly basis and in particular if the units are damaged and there is doubt that the laser heads are still in alignment. Contact your Sealey stockist to arrange returning the unit for re-calibration.
  • Page 4 BATTERY REMOVAL Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.