free stats
Download Print this page
Sealey FGE01 Instructions Manual
Sealey FGE01 Instructions Manual

Sealey FGE01 Instructions Manual

2.5 x 4.5 x 2.5m foldable steel garage extension

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear protective
gloves
instructions
1. SAFETY
Read all safety instructions to reduce the risk of injury or death.
9
This is a temporary structure and is not recommended as a permanent structure.
9
Choose your shelter's location carefully. Check for overhead utility lines, branches, etc. DO NOT install near roofs or other structures
9
that may shed snow, ice or excessive run-off onto your shelter. Keep away from electrical wires!
Install your shelter on a level surface.
9
Check municipal by-laws prior to setting up the product.
9
Have an overview of all parts before attempting installation. Make sure all components are available.
9
DO NOT use this product in environments for which it is not intended (i.e. extreme cold, high winds, extreme heat, heavy rainfall,
8
etc).
Always wear safety glasses when assembling this product. Wear gloves when working with tubing to prevent cuts or abrasions.
9
Anchors must be used with all shelters. Covers should NOT be installed on any product until it has been properly anchored to the
9
ground.
Proper anchoring and keeping cover tight and free of snow and debris, is the responsibility of the consumer.
9
Damages caused by improper anchoring are not covered under warranty.
9
Keep all flame and heat sources away from the shelter fabric. The fabric will burn if left in continuous contact with a flame source.
9
DO NOT use open flames or cooking or heating devices inside or in close proximity to the product, including all types of stoves, gas
8
heaters, gas lanterns, citronella torches, mosquito coils, etc.
DO NOT cook, smoke, refuel or use any open flame devices in or around the shelter.
8
DO NOT store flammable liquids (gasoline, kerosene, propane, etc.) in the shelter.
8
DO NOT operate gas powered vehicles/equipment in or around the shelter.
8
Keep open flames a safe distance away from the shelter.
9
DO NOT use hard-edged tools or instruments, such as rakes or shovels, to remove snow. These can cause punctures to the cover.
8
DO NOT start the engine of any vehicle or machine inside a closed shelter. Ensure that there is adequate ventilation for starting
8
engines and for any work with paints, cleaners, etc.
This shelter is NOT designed to support heavy snow or ice loads. Snow or ice accumulation may cause your shelter to collapse. To
9
avoid overload, brush snow and ice off the roof top with a broom or mop.
To prevent collapse, damage to property, personal injury and/or death, NEVER clear the roof of snow or debris from inside the
9
shelter.
Keep children away during assembly. This product contains small parts which can be swallowed by children.
9
DO NOT attempt to assemble the product if any parts are missing.
8
At least 4 people are needed to complete the assembly as some of the steps require heavy lifting.
9
WARNING! DO NOT leave the shed unattended during assembly. Otherwise, personal injury or damage to the shed may occur
2. INTRODUCTION
Foldable garage extension, perfect for allowing temporary use of a driveway as a garage. Supplied with a powder coated steel frame. 195g/m2
PE Tarp with UV protection and completely waterproof.
3. SPECIFICATION
Model No:...................................................................FGE01
Door Size: .................................. 2500mm (W) x 2000mm (H)
Material: ......................................195g/m2 PE Tarp and Steel
Overall Size (W x D x H): ..............................2.5 x 4.5 x 2.5m
© Jack Sealey Limited
2.5 X 4.5 X 2.5M FOLDABLE STEEL GARAGE
EXTENSION
MODEL NO:
Wear safety
Wear eye
footwear
protection
Original Language Version
FGE01
FGE01 Issue 1 25/11/2020

Advertisement

loading

Summary of Contents for Sealey FGE01

  • Page 1 FGE01 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 WARNING! DO NOT place the product under trees from which hard fruit such as apples, walnuts or heavy pine cones, etc., may ‰ fall. The shed’s cover only protects against normal leaves and light debris, whereas large branches or other falling items may puncture or tear the cover material. FGE01 Issue 1 25/11/2020 Original Language Version © Jack Sealey Limited...
  • Page 3 5.4. STEP 1 (FIG 2) 5.4.1. Take the riser sections out of the box as shown below. 5.4.2. Screw all the casters (fig.2.18) to the bottoms of the legs as per the below diagram. fig.2 FGE01 Issue 1 25/11/2020 Original Language Version © Jack Sealey Limited...
  • Page 4 STEP 3 (FIG.4 & .5) 5.6.1. Follow the below diagrams (fig.4 & .5), assemble the 5 groups of roof structure onto the two sets of Riser Components (fig.4.10 & 11). fig.4 fig.5 5.7. STEP 4 (FIG.6 & 7) 5.7.1. Now assemble pipe Jacking Component (fig.6.12) on top of parts 3 & 4 Brace by M8x70 (fig.6.14) and M8 Nut (fig.6.16). 5.7.2. Please refer to attached diagram of fig. 7, A, B, C, D. Make sure Axle Tube (fig.6.9) is in the right place, either below part 12, or above part 12 to make sure the components are spaced evenly. fig.6 FGE01 Issue 1 25/11/2020 Original Language Version © Jack Sealey Limited...
  • Page 5 5.8.2. Walk around the whole structure, pull the cover tight, and then hook the cover into the suitable hole on the tube legs. 5.8.3. Pull the cover tight onto the frame. Use the ‘hook and loop tape’ straps sewn on the cover to secure it (fig.9). fig.9 FGE01 Issue 1 25/11/2020 Original Language Version © Jack Sealey Limited...
  • Page 6: Maintenance

    Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...

This manual is also suitable for:

5054511915136