How To Set A New Default - Brother MFC-J2510 User Manual
Mfc-j2510; mfc-j4510dw
Hide thumbs
Also See for MFC-J2510:
- Basic user's manual (212 pages) ,
- Quick setup manual (47 pages) ,
- Service manual (374 pages)
Table of Contents
Advertisement
NOTE
• Auto Crop is available for paper with
right angles of 90 degrees at all four
corners. If one of the angles is not square,
Auto Crop cannot detect the document.
• If your document is too long or wide, this
setting does not work correctly. The
document has to meet the following
specification: up to 195 270 mm.
If the ratio between the height and width of
the document is more than 1 to 8, this
setting does not work correctly.
• You must place the documents away from
the edges of the scanner glass as shown
in the illustration.
• You must place the documents at least
10 mm apart from each other.
• Auto Crop adjusts the skew of the
document on the scanner glass, but if your
document is skewed more than
10 degrees, this setting will not work.
• The ADF must be empty to use the
Auto Crop.
• The Auto Crop feature is available for up
to a maximum of 16 documents
depending on the size of your documents.
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while the
machine is reading or writing to the
memory card or USB Flash memory drive
to avoid damaging the card, USB Flash
memory drive, or the data stored on them.
Printing photos from a memory card or USB Flash memory drive
How to set a new default
You can save the Scan to Media settings
(Scan Type, Resolution, File Type,
Auto Crop and
Remove Background Colour) you use
most often by setting them as the default
settings. These settings will remain until you
change them again.
a
b
c
d
e
f
g
h
i
Open the media slot cover.
Put the memory card or USB Flash
memory drive in the correct slot.
Press Scan to Media.
Press Options.
Swipe up or down, or press a or b to
display Scan Type, Resolution,
File Type, Auto Crop or
Remove Background Colour, and
then press the setting you want to
change. Then press the option you want
to change.
Repeat this step for each setting you
want to change.
After you are finished choosing your
preferred settings, swipe up or down, or
press a or b to display
Set New Default.
Press Set New Default.
The Touchscreen asks you to confirm
the change to the new default settings.
Press Yes to confirm.
Press
.
8
8
63
Advertisement
Table of Contents
