Miele CVA 7775 Installation Manual
Hide thumbs
Also See for CVA 7775:
- Operating and installation instructions (116 pages) ,
- Operating and installation instructions (104 pages)
Advertisement
Fresh water connection
Risk of injury and appliance
damage if appliance is not
connected properly.
Failing to connect the appliance
properly can result in personal injury
and / or material damage.
The appliance may only be
connected to the fresh water
connection by qualified specialists.
Risk to health and risk of
damage due to contaminated water.
The quality of the incoming water
must conform to the requirements for
drinking water in the country where
the coffee machine is being used.
Connect the coffee machine to the
drinking water supply.
Connection to the water supply must
comply with the applicable
regulations in the country where the
appliance is being installed. All
appliances and systems used to
supply water to the coffee machine
must also comply with the applicable
regulations in the respective country.
Connect the coffee machine directly
to a fresh water pipe.
Avoid connecting the coffee machine
to a water inlet in which the water
might stagnate. Otherwise, the
flavour of the drinks could be
impaired.
The coffee machine meets the
requirements of IEC 61770 and
EN 61770.
11823040-02
The coffee machine may only be
connected to a cold water supply.
The water connection pressure needs
to be between 100 and 1,000 kPa
(1 and 10 bar).
A faucet must be provided between the
stainless steel hose and the domestic
water supply to ensure that the water
supply can be cut off if necessary.
Make sure the faucet remains easily
accessible once the coffee machine has
been installed.
Connecting the stainless steel hose
to the coffee machine
Only use the stainless steel hose
supplied. The stainless steel hose
must not be shortened, extended, or
replaced by a different hose.
The stainless steel hose must only
be replaced by an original Miele part.
The food-grade, stainless steel hose
is available to order from the Miele
online shop, from Miele Service, or
from your local Miele dealer.
The stainless steel hose supplied is
1.5 m long.
Remove the cover cap from the fresh
water connection at the back of the
coffee machine.
Take the angled end of the stainless
steel hose and check whether there is
a sealing ring. Install one if necessary.
Screw the stainless steel hose
coupling nut onto the thread.
Ensure that it is screwed into position
correctly and watertight.
Installation
Advertisement
Table of Contents
Related Manuals for Miele CVA 7775
Summary of Contents for Miele CVA 7775
- Page 1 Connection to the water supply must The stainless steel hose must only comply with the applicable be replaced by an original Miele part. regulations in the country where the The food-grade, stainless steel hose appliance is being installed. All...
-
Page 2: Installation
*INSTALLATION* 11823040-02 Installation Connecting the water supply Disconnect the coffee machine from the power supply before connecting it to the water supply. Turn off the water supply at the faucet before connecting the coffee machine to the water supply. Make sure that the faucet remains accessible after the machine has been installed. -
Page 3: Electrical Connection
*INSTALLATION* 11823040-02 Installation Electrical connection Before connecting the coffee machine, make sure that the connection data on the data plate (voltage and frequency) matches that of the domestic electrical supply. This data must match to prevent the coffee machine from being damaged. If in any doubt, consult a qualified electrician. -
Page 4: Installation Dimensions
More installation drawings are available on the Miele website. Combination with other Miele Built-in Appliances is possible. If the coffee machine is to be built in above another appliance, there must be a full-width, closed shelf between them. - Page 5 *INSTALLATION* 11823040-02 Installation Installation and connections Cut-out (at least 20" / 508 mm wide) in the base of the tall cabinet for power cord and ventilation Electrical connection W Fresh water connection No electrical or fresh water connection in this area...
-
Page 6: Building In The Coffee Machine
*INSTALLATION* 11823040-02 Installation Building in the coffee machine Risk of damage due to the use of an electric screwdriver. Danger of injury due to incorrect If the coffee machine is secured with operation. an electric screwdriver, e.g., a A machine that has not been built in cordless screwdriver, the chuck may is not safe and can cause injuries. - Page 7 *INSTALLATION* 11823040-02 Installation Useful tip: We recommend providing a place to sit the coffee machine which is the same height as the building-in niche. This will make it easier to connect the machine to the electricity and water supply. Connecting the fresh water and electricity supplies Observe the information under “Fresh water connection”...