Cannot Use The Printer On Replacing An Access Point Or Changing Its Settings - Canon iX6800 Series Online Manual
Hide thumbs
Also See for iX6800 Series:
- Online manual (495 pages) ,
- Quick installation (4 pages) ,
- Installation manual (4 pages)
Table of Contents
Advertisement
Cannot Use the Printer on Replacing an Access Point or Changing
Its settings
When you replace an access point, perform network setup of the printer again.
Perform network setup again with the Setup CD-ROM or perform it again according to the instructions on
our website.
If the problem is not resolved, see below.
Cannot Communicate with the Printer After Applying MAC/IP Address Filtering or Entering a WEP/WPA/
WPA2 Key to the Access Point
When Encryption Is Enabled, Cannot Communicate With the Printer After the Encryption Type Was
Switched on the Access Point
Cannot Communicate with the Printer After Applying MAC/IP Address
Filtering or Entering a WEP/WPA/WPA2 Key to the Access Point
Confirm the access point setting.
Check1
Refer to the instruction manual provided with the access point or contact its manufacturer to confirm the
access point setting. Make sure that the computer and the access point can communicate with each other
under this setting.
If you are performing MAC address filtering or IP address filtering at the
Check2
access point, confirm that the MAC address or IP address for both the computer or the
network device and the printer are registered.
If you are using a WEP/WPA/WPA2 key, make sure that the key for the
Check3
computer or the network device and the printer matches that set to the access point.
Besides the WEP key itself, the key length, key format, the key ID to use, and the authentication method must
match among the printer, the access point, and the computer.
Normally, select Auto for the authentication method. If you want to specify the method manually, select Open
System or Shared Key according to the setting of the access point.
How to Set a WEP/WPA/WPA2 Key
When Encryption Is Enabled, Cannot Communicate With the Printer After
the Encryption Type Was Switched on the Access Point
If the printer cannot communicate with the computer after the encryption type of the printer was switched,
make sure that encryption types for the computer and the access point matches that set to the printer.
Cannot Communicate with the Printer After Applying MAC/IP Address Filtering or Entering a
WEP/WPA/WPA2 Key to the Access Point
354
Advertisement
Table of Contents
