C H A P T E R 3 Connecting And Setting Up Your Laptop Computer; About Configuring Your Laptop - Cisco 700 MHz Installation And Upgrade Manual
Audio server
Hide thumbs
Also See for 700 MHz:
- Configuration manual (87 pages) ,
- Administration manual (36 pages) ,
- Getting started manual (27 pages)
Table of Contents
Advertisement
About Configuring Your Laptop
Figure 3-1
Step 2
Connect one end of the null modem cable to the COM 1 port on the CPU card in the front of the Cisco
Unified MeetingPlace Audio Server.
Step 3
Connect the other end of the null modem cable to the COM port on your laptop.
About Configuring Your Laptop
You can access the Command Line Interface (CLI) command screen by running terminal emulation
software, such as ProComm, Windows Terminal, or HyperTerminal. Configure your laptop COM port
with the parameters listed in
Table 3-1
Parameter
Baud Rate
Data Length
Parity
Stop Bits
No phone number or area code is needed for direct connections to a COM port. Depending on the
configuration of the laptop, the direct connection (9-pin connector) may be any of the COM ports, but
it most likely is COM 1.
Set up the terminal emulation software to emulate a VT100 terminal. If your laptop is connected to a
Cisco Unified MeetingPlace Audio Server and the operating system is running, the login prompt
appears. It is sometimes necessary to press Enter once or twice.
The default username is admin, and the default password is cisco.
If the Cisco Unified MeetingPlace Audio Server is not powered on yet, you will not see the login prompt.
Note
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
3-2
Null Modem Cable Pinouts
Table
3-1.
Laptop COM Port Parameters
Value
19200
8 bits
None
1
Chapter 3
Connecting and Setting Up Your Laptop Computer
OL-13417-01
Advertisement
Table of Contents
Troubleshooting
