Welcome Thank you for choosing the Cisco 300 Series Managed Switch, a Cisco Small Business network communications device. This device is designed to be operational right out of the box as a standard bridge. In the default configuration, it will forward packets between connecting devices after power up.
3.7 inches (95 mm) apart, attaching the provided anchors and screws to the wall, then sliding the switch into position on the screws. The switch should have a minimum of 5 inches (130 mm) of clearance on all sides. 300 Series Managed Switches...
If your switch is one of the PoE models, consider the following: As a PSE (Power Sourcing Equipment) device, the switch can deliver a maximum of 15.4 Watts per PoE port to a PD (Powered Device). Step 2 for each device you want to connect to 300 Series Managed Switches...
Ethernet cable, or by connecting to the same LAN where the switch is located through other switches. You can also connect your computer to the switch from another IP subnet through one or more IP routers. 300 Series Managed Switches...
Page 6
The Getting Started window displays. You are now ready to configure the Cisco Small Business Managed Switch Administration switch. Refer to the Guide for further information. Change Password Page 300 Series Managed Switches opens. Enter...
Page 7
• Return your computer to its original settings These tasks can be accomplished by using the procedures in the Cisco Small Business Managed Switch Administration Guide. 300 Series Managed Switches Change User Password Page Cisco Small for further information. opens.
LED. You can determine the current IP address of the switch from the menu CLI through the console port interface, or from your network administrator. Make sure that no other device is using the same IP address as the switch. 300 Series Managed Switches...
• MiniGBIC interface is a combination port, shared with one other RJ-45 interface. When the MiniGBIC is active, the adjacent RJ-45 port is disabled. • The LEDs of the corresponding RJ-45 port light to respond to the miniGBIC interface traffic. 300 Series Managed Switches...
Additional Front Panel Features The switch also has a reset button. The switch can be reset by inserting a pin or paper clip into the reset opening. See “Returning the Device to the Factory Default Settings” details. 300 Series Managed Switches...
1. Disconnect the managed switch from the network or disable all DHCP servers on your network. 2. With the power on, press-and-hold the 10 seconds. 300 Series Managed Switches Reset button for less than 10 Reset button for more than...
Resources Phone Support Contacts Cisco Small Business Firmware Downloads Product Documentation Cisco Small Business Managed Switches 300 Series Managed Switches Quick Start Guide 300 Series Managed Switches Administration Guide Regulatory, Compliance, and Safety Information Warranty Information Cisco Small Business...
Page 16
Small Business Support US: 1-866-606-1866 (Toll Free, 24/7) Small Business Support, Global: www.cisco.com/go/sbsc Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at www.cisco.com/go/...