Table of Contents
Advertisement
Steps
1. Align and place the smart card reader on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the smart card reader to the palm-rest and keyboard assembly.
3. Adhere the smart card reader cable on the palm-rest and keyboard assembly.
4. Connect the smart card reader cable to the connector on the USH board.
Next steps
1. Install the
assembly inner
2. Install the battery.
3. Install the
hard
drive.
4. Install the
WWAN
card.
5. Install the
wireless
card.
6. Install the
2280 solid-state drive
7. Install the
base
cover.
8. Install the
microSD
card.
9. Install the
SIM
card.
10. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
CAUTION:
Removing the coin-cell battery resets the BIOS setup program's settings to default. It is
recommended that you note the BIOS setup program's settings before removing the coin-cell battery.
2. Remove the
SIM
card.
3. Remove the
microSD
4. Remove the
base
cover.
5. Remove the
2280 solid-state drive
6. Remove the battery.
7. Remove the
hard
drive.
8. Remove the
wireless
card.
9. Remove the
WWAN
card.
10. Remove the
assembly inner
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
80
Removing and installing components
frame.
or
2230 solid-state
After working inside your
Before working inside your
card.
or
2230 solid-state
frame.
drive.
computer.
computer.
drive.
Advertisement
Table of Contents
