Table of Contents
Advertisement
Table 43. Configuration type C2 (continued)
Card Type
Foxconn external adapter
H840
Foxconn external adapter
HBA355e
aPERC HBA11 HBA355i
Removing a expansion card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
Steps
1. Disconnect the cables from the expansion card.
2. Press the expansion card latch and push down the latch to open it.
3. Hold the expansion card by the edge, and pull the card up to remove it from the expansion card connector and the system.
Figure 128. Removing an expansion card
4. Install the filler brackets by performing the following steps:
a. Align the slot on the filler bracket with the tab on the expansion card slot.
b. Press the expansion card latch till the filler bracket locks into place.
NOTE:
Filler brackets must be installed in empty expansion-card slots to maintain FCC certification of the system. The
brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
128
Installing and removing system components
Slot priority
1, 2, 4, 6, 3
1, 2, 4, 6, 3
6
Safety
instructions.
Before working inside your
Maximum number of cards
5
5
1
system.
Advertisement
Table of Contents
