Advertisement
Quick Links
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
Keep in dry area
protect from rain
1. SAFETY
ELECTRICAL SAFETY
1.1.
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
9
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products.
Electrical safety information. It is important that the following information is read and understood:
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
9
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
9
Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is replaced immediately by a
8
qualified electrician.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
1.2.
BATTERY CHARGER SAFETY INSTRUCTIONS
9
Familiarise yourself with the applications, limitations and potential hazards relating to the starter/charger. Also refer to the vehicle
manufacturer's handbook. IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN.
Ensure the starter/charger is in good order and condition before use. If in any doubt, do not use the unit and contact an electrician.
9
Only use genuine parts. To use unapproved parts may be dangerous and will invalidate your warranty.
9
Use the starter/charger in the horizontal position only and ensure it stands on a stable surface which will adequately support the weight.
9
Ensure the charger is switched off and disconnected from the mains power supply before attaching the power clamps to the battery.
9
Keep tools and other items away from the engine and ensure that you can see the battery and working parts of the engine clearly.
9
If the battery has removable caps to access the battery fluid, remove the caps and check the fluid level before connecting the power
9
leads.
If necessary top-up the battery with distilled water by referring to the battery manufacturer's instructions, (apply the personal safety
precautions described in para. 1.2.).
DO NOT dis-assemble the starter/charger for any reason. It must be checked by qualified service personnel only.
8
The cables may become hot with excessive use. If so, allow a few minutes for them to cool down before attempting to re-use.
9
If the starter/charger receives a sharp knock or blow, the unit must be checked by a qualified service agent before using.
9
When not in use, store the starter/charger carefully in a safe, dry, childproof location.
9
Ensure the positive cable is connected to the correct voltage connection on the charger as for the voltage of the battery being charged.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT try to charge a non-rechargeable battery.
8
DO NOT try to start with a frozen battery. DO NOT attempt to charge a frozen battery.
8
WARNING! DO NOT allow metal tools to touch both battery terminals at the same time. The resulting spark or short circuit may cause
‰
an explosion.
DO NOT pull the cables or clamps from the battery terminals.
8
DO NOT use this product to perform a task for which it is not designed.
8
© Jack Sealey Limited
ELECTRONIC STARTER/CHARGER/MAINTAINER
300/45A 12/24V
ECS300.V2
MODEL NO:
Wear protective
Electrical
gloves
shock
hazard
Original Language Version
Warning
Warning:
corrosive
explosive
substance
Use in well
Keep away
ventilated areas
from sources of
ignition
ECS300.V2 Issue 2 (2) 15/01/24
Advertisement
Related Manuals for Sealey ECS300.V2
Summary of Contents for Sealey ECS300.V2
- Page 1 ECS300.V2 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
-
Page 2: Specification
Push outer protection pieces onto the ends of the clamp. 4.6.5. Slide insulating handles up to meet the outer protection pieces. 4.6.6. Repeat for all four clamps. fig.2 For reference. fig.1 Supplied assembled. Original Language Version © Jack Sealey Limited ECS300.V2 Issue 2 (2) 15/01/24... - Page 3 Languages supported: • Italian • English. Once the language is set, to quit the menu press the A/V button for a few seconds. Original Language Version © Jack Sealey Limited ECS300.V2 Issue 2 (2) 15/01/24...
- Page 4 Supports batteries from 30Ah - 70Ah. Output current adjusted automatically. 6.3. BATTERY TYPE Wet: Acid electrolyte batteries. Agm Spiral Cell: AGM batteries with flat plate or Optima type spiral cell. Original Language Version © Jack Sealey Limited ECS300.V2 Issue 2 (2) 15/01/24...
-
Page 5: Operation
Based on the capacity of the battery and on the work cycle, select: - Charge 30Ah/70Ah: Charge for batteries with capacity from 30Ah to 70Ah. - Charge 80Ah/120Ah: Charge for batteries with capacity from 80Ah to120Ah. Original Language Version © Jack Sealey Limited ECS300.V2 Issue 2 (2) 15/01/24... -
Page 6: Maintenance
Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 24 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk...