Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling This document describes the interoperability and configuration of a Cisco 2621 voice gateway with a Lucent/Avaya Definity G3si PBX using E1 PRI NET5 signaling. It includes the following sections: System Components...
Page 2
Cisco 2621 voice gateway via an E1 PRI connection. Set Up Notes The Cisco 2621 Gateway with ISDN protocol type setting of primary-net5 supports both protocol sides by using the isdn protocol-emulate network/user command. The Lucent/Avaya Definity G3si PBX supports both “USER” and “NETWORK” protocol sides by using change ds1 a12 command.
Page 3
Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling Lucent/Avaya PBX Configuration Lucent/Avaya PBX Version Information Software: Version 7.0 Hardware: TN464F, DS1 INTFC 24/32 Page 3...
Page 14
Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling Page 14...
Page 15
Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling Page 15...
Page 16
Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling Route Pattern Configuration Page 16...
Page 17
Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling Cisco 2621 Gateway Configuration The following is the configuration of the Cisco 2621 voice gateway connected to the Lucent/Avaya Definity G3si PBX E1 PRI interface. Cisco 2621 Voice Gateway Version Information...
Page 18
Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling Channelized E1, Version 1.0. Bridging software. X.25 software, Version 3.0.0. SuperLAT software (copyright 1990 by Meridian Technology Corp). TN3270 Emulation software. Primary Rate ISDN software, Version 1.1. 2 FastEthernet/IEEE 802.3 interface(s)
Page 19
Cisco 2621 Gateway-PBX Interoperability: Lucent/Avaya Definity G3si with E1 PRI NET5 Signaling load-interval 30 no keepalive speed auto half-duplex interface FastEthernet0/1 ip address 10.1.1.129 255.255.255.0 no ip mroute-cache duplex auto speed auto interface Serial1/0:15 no ip address no logging event link-status...
Page 20
When calling from Cisco 7960 IP phone to Lucent/Avaya digital phone, Lucent/Avaya phone displays Calling Name and Number after the call is answered as expected. Cisco 7960 phone however only displays “Called Number” but no “Connected Name” even though Lucent/Avaya PBX was sending both “Connected Name”...