Lenovo J100 Notice
Notice to new zealand users
Hide thumbs
Also See for J100:
- Quick reference (453 pages) ,
- Hardware maintenance manual (218 pages) ,
- Kurzübersicht (102 pages)
Advertisement
Quick Links
Notice to New Zealand Users
Conexant RD01-D850 Data Fax PCI Modem - PTC 211/03/066
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It indicates
no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it
provides no assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model, nor does it imply that any product is
compatible with all of Telecom's network services.
2. This equipment is not capable, under all operating conditions, of correct operation at the higher
speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such
circumstances. This condition typically applies to 56 kbit/s modems.
3. This equipment does not fully meet Telecom's impedance requirements. Performance limitations may
occur when used in conjunction with some parts of the network. Telecom will accept no responsibility
should difficulties arise in such circumstances.
4. The equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service.
5. This device may be subject to ringing or bell tinkle when certain other devices are connected to the
same line. If this occurs, the problem should not be referred to the Telecom Faults Service.
6. This equipment should not be used under any circumstances that may constitute a nuisance to other
Telecom customers.
7. Some parameters required for compliance with Telecom's Telepermit requirements are dependent on
the application software. The application software shall be set to operate within the following limits
for compliance with Telecom's specifications:
v The S0 register must contain a value of 0 for no auto-answer or a value of 3 to 8 for auto answer.
The factory default is 3.
v The S6 register must contain a value of 4, 5, 6 or 7. The factory default of 4 is recommended.
v The S7 register must contain a value of less than 80. The factory default is 60.
v The S10 register must contain a value of less than 140. The factory default is 14.
v The S11 register must contain a value of greater than 60. The factory default is 85.
v There shall be no more than 10 call attempts to the same number within any 30-minute period for
any single manual call initiation.
v The equipment shall go on-hook for a period of not less than 30 seconds between the end of one
call attempt and the beginning of the next attempt to the same number.
v Automatic calls to different numbers shall be not less than 2 seconds apart.
v Failure to set these parameters correctly could negate the User Rights under the Telecom Terms of
Service.
Advertisement
Related Manuals for Lenovo J100
Summary of Contents for Lenovo J100
- Page 1 Notice to New Zealand Users Conexant RD01-D850 Data Fax PCI Modem - PTC 211/03/066 1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
- Page 2 U.S. GOVERNMENT USERS – RESTRICTED RIGHTS: Our products and/or services are provided with RESTRICTED RIGHTS. Use, duplication or disclosure by the Government is subject to the GSA ADP Schedule contract with Lenovo Group Limited, if any, or the standard terms of this commercial license, or if the agency is unable to accept this Program under these terms, then we provide this Program under the provisions set forth in Commercial Computer Software–Restricted Rights at FAR 52.227-19, when applicable, or under Rights in Data-General, FAR 52.227.14...