10. Slide the new secondary hard disk drive into the bracket until it snaps into position.
Figure 51. Installing the secondary hard disk drive
11. Connect the signal cable and the power cable to the new secondary hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 93.
Replacing the secondary hard disk drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the secondary hard disk drive.
To replace the secondary hard disk drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 32.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 32.
4. Press the release tab
1
as shown and pivot the drive bay assembly upward.
.
Chapter 5
Installing or replacing hardware
57