Table of Contents
Advertisement
6 Replace and tighten the four screws to secure the hard drive.
7 Connect the power and data cables to the drive.
8 Connect the data cable to the system board.
9 Check all cables to be certain that they are properly connected and firmly
seated.
10 Replace the computer cover (see "Replacing the Computer Cover" on
page 160).
NOTICE:
device and then plug it into the computer.
11 Connect your computer and devices to electrical outlets, and then turn
them on.
12 See the documentation that came with the drive for instructions on
installing any software required for drive operation.
13 Check the System Setup for drive configuration changes (see "Entering
System Setup" on page 168).
Installing a Second Hard Drive
CAUTION:
safety instructions in the Product Information Guide.
CAUTION:
the electrical outlet before removing the cover.
NOTICE:
the drive on a surface, such as a foam pad, that will sufficiently cushion it.
NOTE:
For additional drives, extra screws are not shipped during initial purchase of
the computer, but are shipped with the additional drives.
1 Follow the procedures in "Before You Begin" on page 99.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3 Check the documentation for the drive to verify that it is configured for
your computer.
4 Slide the second hard drive into the second hard drive bay.
5 Align the screw holes in the second hard drive with the screw holes in the
second hard drive bay.
128
Removing and Installing Parts
To connect a network cable, first plug the cable into the network port or
Before you begin any of the procedures in this section, follow the
To guard against electrical shock, always unplug your computer from
To avoid damage to the drive, do not set it on a hard surface. Instead, set
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
