Page 1
Operating and installation instructions Open barbecue grill CS 1312 BG CS 1322 BG en - AU, NZ To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time.
Guide to the appliance CS 1312 a Grill rack Controls for the heating elements: b Front heating element h Front c Rear heating element i Rear d Lava rock container e Drain tap Display f Symbols to indicate which heating element the control is for g Display j In-operation indicator...
Page 5
Guide to the appliance CS 1322 a Grill rack Controls for the heating elements: b Front heating element h Front c Rear heating element i Rear d Lava rock container e Drain tap Display f Symbols to indicate which heating element the control is for g Display j In-operation indicator...
Page 6
Guide to the appliance Accessories supplied Additional accessories can be ordered at extra cost. See "Optional accessories" for further details on ordering. Lava rocks Tongs Brush...
They contain important notes on Any other usage is at the owner's risk installation, safety, use and and could be dangerous. Miele cannot maintenance. be held liable for damage resulting from incorrect or improper use or Keep these instructions in a safe operation.
Page 8
Warning and Safety instructions Safety with children Ensure that children cannot reach the drain tap where hot liquid could be Children should be supervised to drained out. ensure that they do not play with the appliance. Packaging, e.g. cling film, polystyrene and plastic wrappings, Older children may only use the grill must be kept out of the reach of babies...
Page 9
Do not install and use a damaged national and local safety regulations. appliance. A damaged appliance is Repairs and other work by unqualified dangerous. persons could be dangerous. Miele The electrical safety of this cannot be held liable for unauthorised appliance can only be guaranteed work.
Page 10
H 05 VV-F switched off. (pvc insulated), available from Miele. Caution: Danger of burning. Do not connect the appliance to the Do not leave the appliance mains electricity supply by a unattended whilst it is being used.
Page 11
Do not cover the appliance, e.g. with a covering plate, a cloth, kitchen Miele cannot be held liable for foil etc. If the appliance is switched on damage caused by non-compliance by mistake, or if there is residual heat,...
Caring for the environment Disposal of the packing Disposal of your old appliance material or machine The transport and protective packing Electrical and electronic appliances / has been selected from materials which machines often contain materials are environmentally friendly for disposal which, if handled or disposed of and can normally be recycled.
Before using for the first time Please stick the extra data plate for the The metal components have a appliance supplied with this protective coating which may give off documentation in the space provided in a slight smell when heated up for the the "After sales service"...
Operation Grill chart The times given in the table serve as a guide, based on a pre-heated grill at settings 9 to 12. The grilling time required will depend on the type of food, its texture and thickness as well as personal taste. Food Time in minutes Meat and sausages...
Page 15
Operation Food Time in minutes Vegetables Eggplants 6 - 8 Jacket potatoes, pre-cooked 10 - 20 Vegetarian kebabs 5 - 6 Corn on the cob, pre-cooked 5 - 8 Capsicum, cut into strips 2 - 3 Tomato halves 2 - 4 Fruit Pineapple slices 2 - 3...
Operation To prepare the grill Switching on and off The grill can be used with or without the The grill has 2 heating elements which lava rocks, but always with water in the can be switched on and regulated trough. Without the lava rocks the rising independently.
Operation Grilling Useful tips – Pat dry wet food with kitchen paper When grilling, keep an eye on the to absorb surplus moisture and avoid level of water in the trough. If spitting. necessary, add more water. – To prevent meat drying out, do not When grilling or keeping food warm, season with salt until after it has do not use grill pans, griddles,...
Safety features Overheating protection Safety cut-out A safety cut-out automatically switches A safety cut-out ensures that the grill the appliance off if the water level elements only heat up when they are drops too low. lying horizontally and not when they are raised up.
Cleaning and care To avoid damaging the stainless Under no circumstances use a steel surfaces of your appliance, do steam cleaning appliance to clean not use: this appliance. The steam could – cleaning agents containing soda, attack the electrical components alkalines, ammonia, acids or and cause a short circuit.
Page 20
Cleaning and care Stainless steel Racks and lava rock container The Original Miele ceramic and Wash the racks and lava rock container stainless steel cooktop cleaner is after every use in hot water and a small suitable for cleaning stainless steel amount of washing-up liquid.
Page 21
Cleaning and care Grill trough Ensure that the underside of the grill ^ After grilling, allow the water in the is always easily accessible for trough to cool down before draining draining water. Always wait until the water has cooled down before ^ Place a container large enough to draining to avoid the danger of take the contents of the trough under...
– the mains fuse has tripped. If it has, contact a qualified electrician or Miele..the food does not begin to brown when the appliance has been pre-heated at setting "12" for 10 minutes.
Optional accessories Miele offers a range of useful accessories, as well as cleaning and conditioning products for your appliance. These can be ordered via the internet at www.miele-shop.com (depending on country) or from Miele (see back cover). Griddle CSGP 1300...
Page 24
Optional accessories Original Miele stainless steel conditioning agent 250 ml Removes water marks, flecks and finger prints. Helps keep the appliance looking good for longer. Original Miele all-purpose microfibre cloth Removes finger marks and light soiling.
Safety instructions for installation All dimensions in this instruction booklet Fit the wall units and rangehood are given in mm. before fitting the barbecue grill to avoid damaging the surface. This appliance must be installed The veneer or laminate coatings of and connected to services in worktops (or adjacent kitchen units) accordance with local and national...
Safety clearance Safety clearance above the grill When two or more appliances are installed together below a rangehood, e.g. a grill and an induction cooktop combiset, which have different safety clearances given in the installation instructions, you should select the greater distance of the two.
Page 27
Safety clearance Side / rear clearances to the cooktop Ideally the cooktop should be installed with plenty of space on either side. There may be a wall at the rear and a tall unit or wall at one side. On the other side, however, no unit or divider should stand higher than the cooktop (see illustrations).
Appliance and building-in dimensions CS 1312 a Spring clamps b Front c Building-in depth d Installation height of mains connection box with mains connection cable, L = 2,000 mm e Drain tap...
Page 29
Appliance and building-in dimensions CS 1322 a Spring clamps b Front c Building-in depth d Installation height of mains connection box with mains connection cable, L = 2,000 mm e Drain tap...
Preparing the worktop ^ Make the worktop cut-out for one or more appliances as applicable. Remember to maintain a minimum safety clearance from the back wall, as well as from any tall unit or side wall to the right or left of the appliance(s).
Installation of several appliances When installing two or more appliances next to each other, a spacer bar b must be used between each one. See "Fitting the spacer bars and support brackets". Worktop cut-out Worktop cut-out - two appliances - three appliances When installing three appliances, the When installing two appliances, the width of the cut-out required (D) is...
Page 32
Installation of several appliances Worktop cut-out calculation example for three appliances Appliance width Appliance Appliance width Worktop less 8 width less 8 cut-out 1032 1424 1124 1516 1136 1320 1136 All dimensions are given in mm...
Page 33
Installation of several appliances a Spring clamps b Spacer bars c Gap between spacer bar and worktop d Cover The illustration shows a worktop cut-out with spring clamps a and spacer bars b for 3 appliances. An additional spacer bar is required for each additional appliance. The position for securing each additional spacer bar will depend on the width of appliance B (288 mm / 380 mm / 576 mm).
Fixing the spring clamps and spacer bars Wooden worktops ^ Position the spring clamps supplied a and spacer bars b on the top edge of the cut-out in the positions marked. ^ Secure the spring clamps and spacer bars with the 3.5 x 25 mm screws supplied.
Page 35
Fixing the spring clamps and spacer bars Granite and marble worktops The screws are not required for granite or marble worktops. ^ Coat the side edges and the lower edges of the spring clamps a and the spacer bars b with silicone. ^ Then fill gap e between the spacer ^ Position and secure the spring bars and the worktop with silicone.
In stubborn cases, or if the appliance is When installing several appliances, a not accessible from below, use a cover must be inserted into the spacer cooktop lever (available from Miele) to bar. lift up the cooktop. To prevent damage ^ Slide the installed appliance to one...
General installation tips Seal between the appliance and the Tiled worktop worktop Grout lines a and the hatched area underneath the appliance frame must be smooth and even. If they are not, the The sealing strip under the edge of the appliance will not sit flush with the top part of the appliance provides a worktop and the sealing strip...
As the colours of the wires in the mains connection cable of type H 05 V V-F lead of this appliance may not (pvc insulated), available from Miele. correspond with the coloured markings For extra safety, it is advisable to install...
After sales service, data plate The address and phone number of your nearest Miele office is given on the back page. The voltage and rated load are given on the data plate. Please quote this data, together with the model description and serial number when contacting Miele.