free stats
Download Print this page
NEC Door Box 92245 Installation

NEC Door Box 92245 Installation

Advertisement

Quick Links

Door Box (P/N 92245) Installation
The Door Box (P/N 92245) is a self-contained Intercom unit typically used to monitor an entrance door. A visitor at the door can press
the Door Box call button (like a door bell). The Door Box then sends chime tones to all extensions programmed to receive chimes.
Your Door Box unit could be either of the designs shown at right. For installation, refer to the figure that applies to your Door Box.
Installing a Door Box
1. Locate an available 2-pin connector in a miscellaneous block.
2. For the connector chosen, cross-connect the associated wire pair
from the miscellaneous block to the cross-connect block.
3. Connect leads from the lugs on the Door Box (numbered 1 and 2 on
the figures at right) to the cross-connect block. Be sure to maintain the
proper polarity.
4. Install bridging clips as required.
5. For system connections, refer to the section that applies to your system.
6. Refer to the system's installation manual for relay connections, if required.
Misc.
Block
cable to system
connection (DDK
connector on PCB for
Portrait 824 and 28i/124i,
48FU connector for
384i/704i systems)
Design A
*
RED-BRN
BRN-RED
*
RED-SLT
SLT-RED
* typical installation
Design B
Cross-
Connect
Cross-
to 66M1-
Connect
50 Block
to 66M1-
50 Block
Misc Block
- over -
To Door Chime Box 1
21
22
23
To Door
24
Chime Box 2
Misc Block
Holes for
mounting screws
L
T
C
T
1
2
To Door Chime Box 1
21
To Door Chime Box 1
22
23
To Door
21
24
22
Chime Box Relay
23
To Door
24
Chime Box Relay
Misc Block
Holes for
Holes for
mounting screws
mounting screws
5
L
T
6
C
T
1
2
3
4
L
F
Rear view
L
T
C
T
L
F
1
2
3
L
F
3
Rear view
Rear view

Advertisement

loading

Summary of Contents for NEC Door Box 92245

  • Page 1 Door Box (P/N 92245) Installation The Door Box (P/N 92245) is a self-contained Intercom unit typically used to monitor an entrance door. A visitor at the door can press the Door Box call button (like a door bell). The Door Box then sends chime tones to all extensions programmed to receive chimes. Your Door Box unit could be either of the designs shown at right.
  • Page 2 Circuit (e.g., VR1 corresponds to Door Box 1). 5. Refer to the system’s software manual for programming information. 4PGDU PCB NEC America Inc., Corporate Networks Group 4 Forest Parkway, Shelton, CT 06484 P/N 92245INS02 April 2001 TEL: 203-926-5400 FAX: 203-929-0535 Issue 1-0 Printed in U.S.A.