[ 8 ] Installing the Bottom Cover
(1) As shown below, route the power supply harness through the grooves provided on
the bottom cover and then connect it to the main PCB.
(2) Align the front edge of the bottom cover with that of the body cover, then push down
the bottom cover until it snaps into place.
• Take care not to pinch the cords between those covers.
(3) Secure the bottom cover with seven screws.
Tightening torque:
Figure 2.2-23 Installing the Bottom Cover (1)
392 ±196 mN•m (4 ±2 kgf•cm)
Figure 2.2-24 Installing the Bottom Cover (2)
II - 23