Dell PowerEdge R630 Owner's Manual page 108
Hide thumbs
Also See for PowerEdge R630:
- Owner's manual (207 pages) ,
- Technical manual (59 pages) ,
- Installing manual (18 pages)
Table of Contents
Advertisement
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the hard drives and hard-drive backplane, you must remove the
hard drives from the system before removing the hard-drive backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before
removal so that you can replace them in the same locations.
Steps
1.
Disconnect the SAS/SATA/SSD data cable(s) and power cable from the backplane.
2.
If applicable, disconnect the power/data cable from the optical drive.
3.
Push the backplane blue release tabs in the direction of the arrows and lift the backplane upwards.
4.
Pull the backplane away from the system until the securing slots on the backplane are free from the
tabs on the chassis.
Figure 48. Removing and installing the 2.5 Inch (x8) hard-drive backplane
1.
backplane
3.
backplane signal cable
5.
release tabs (2)
7.
SAS hard-drive connector on backplane
108
2.
backplane signal cable
4.
SAS A cable
6.
SAS B cable
Advertisement
Table of Contents
Troubleshooting
