Rear Suspension - Suzuki 2006 SX4 Service Manual

Hide thumbs Also See for 2006 SX4:

Table of Contents

0A-5 General Information:

Vehicle Lifting Points

• Before applying hoist to underbody, always take vehicle balance throughout service into

consideration. Vehicle balance on hoist may change depending on what part to be removed.

• Before lifting up the vehicle, check to be sure that end of hoist arm is not in contact with brake pipe,

fuel pipe, bracket or any other part.

• When using frame contact hoist, apply hoist as shown (right and left at the same position). Lift up

the vehicle till 4 tires are a little off the ground and make sure that the vehicle will not fall off by

trying to move vehicle body in both ways. Work can be started only after this confirmation.

• Make absolutely sure to lock hoist after vehicle is hoisted up.

When Using Frame Contact Hoist

1. Vehicle front

2. Support position for frame contact hoist and safety stand

When Using Floor Jack

If the vehicle to be jacked up only at the front

or rear end, be sure to block the wheels on

ground in order to ensure safety.

After the vehicle is jacked up, be sure to

support it on stands. It is extremely

dangerous to do any work on the vehicle

raised on jack alone.

3. Floor jack position

4. Body mounting stay

Never apply jack against rear suspension

parts (i.e., torsion beam, etc.) or vehicle floor,

or it may get deformed.

S6RW0D0101005

I5RW0A010001-02

Chapters

Table of Contents