Table of Contents
Advertisement
■ Affixing the NFC Target
1
Setting after Installation
1. Connect the power plug of the host machine to the
outlet.
2. Turn ON the main power switch.
3. If a message prompting the user to update the
version appears, press [Update] to automatically
update the version of this equipment.
NOTE:
If [Skip] is selected, a message prompting the user to
update the version will appear every time the host machine
is started.
In the service mode (Level 2) shown below, it is possible
to set not to display the message.
• COPIER > OPTION > FNC-SW > VER-CHNG
4. After the version update, enter service mode (Level
1) and set the value to "1".
• COPIER > FUNCTION > INSTALL > NFC-USE
NOTE:
When [System Manager Information Settings] is set, it is
required to log in as a system manager in accordance with
instructions of the user administrator.
5. Select [Settings/Registration] > [Management
Settings] > [Device Management] > [Use NFC Card
Emulation], and set the item to "ON".
6. Turn OFF and then ON the main power switch.
7. When a message prompting the version update is
displayed, press [Update] and automatically update
the version of this equipment.
CAUTION:
It may take time to display the update screen. (Approx.
1 to 2 min.)
During this time, do not operate the screen.
8. Check the end of the following service mode (Level
1).
• COPIER > DISPLAY > VERSION > PANEL
If the end is an even number (e.g. 01.26): NFC is
not installed.
If the end is an odd number (e.g. 01.27): NFC is
installed.
927
9. Installation
Advertisement
Table of Contents
Troubleshooting
