Table of Contents
Advertisement
Assembling Note:
• If you removed the Motor drive sub ASSY while the Fuser unit was attached on the
machine, remove the Fuser unit once (refer to
attaching the Motor drive sub ASSY.
The Conductive leaf spring of the Fuser unit may be deformed by the Calking shaft. If
they are not in contact properly, a ghost may occur in the printed image.
Conductive leaf
spring
Calking shaft
(5) Remove the Gear115L 30L drum, the Gear 50L PF, the Clutch PF, and the Gear 23R PF
from the Frame L unit.
(6) Remove the Gear 68R drum idle from the Motor plate ASSY, and remove the Motor plate
ASSY from the Frame L unit.
(7) Remove the three Screw bind M3x4 screws, and remove the Paper feed motor from the
Motor plate ASSY.
(8) Disconnect the Paper feed motor flat cable from the Paper feed motor.
Paper feed motor flat cable
Screw bind M3x4
Motor plate ASSY
Paper feed motor
"9.10 Fuser
unit") and reattach it after
Fig. 3-52
Gear 68R drum idle
Fig. 3-53
3-54
Fuser unit
Gear115L 30L drum
Gear 50L PF
Clutch PF
Gear 23R PF
Frame L unit
Confidential
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
