hit counter script
Download Print this page
Canon imageCLASS MF5730 Setup Instructions
Canon imageCLASS MF5730 Setup Instructions

Canon imageCLASS MF5730 Setup Instructions

Canon imageclass mf5730: setup instruction
Hide thumbs Also See for imageCLASS MF5730:

Advertisement

Thank you for purchasing Canon imageCLASS MF5730.
To get your machine ready for use, please follow the instructions in this document before referring to any other documentation.
Unpack the machine and its components.
Check that you have the following:
Machine
Power cord
USB cable
Set-Up Instructions
NOTE
The cartridge included with the machine is Cartridge X25 that yields approximately 2,500 pages of printouts (Letter at 4%
dot coverage).
Before setting up the machine:
1 Place the machine on a flat, stable surface.
2 Remove all shipping tape from the exterior of the machine.
Referring to the following figure, remove the tape and spacers on both sides of the
cassette housed in the machine.
Set-Up Instructions
Set-Up Instructions
Cartridge
Extension cover
Basic Guide
Warranty
Limited Warranty Note for Cartridge X25
Registration Card
MF5700 Series User Software CD-ROM
Cassette extension

Advertisement

loading

Summary of Contents for Canon imageCLASS MF5730

  • Page 1 Set-Up Instructions Set-Up Instructions Thank you for purchasing Canon imageCLASS MF5730. To get your machine ready for use, please follow the instructions in this document before referring to any other documentation. Unpack the machine and its components. Check that you have the following: ●...
  • Page 2: Install The Cartridge

    Install the cartridge. 1 Remove the cartridge from the bag. Keep the bag in a safe place for future use. 3 Hold the cartridge on a flat stable surface with ➊ one hand, and break the tab ➋ the seal completely with the other hand.
  • Page 3 3 Attach the extension to the cassette. The slots ➊ are keyed and must be inserted at a 90° angle. Once inserted, fold the extension as shown ➋. To load Legal-size paper: ➊ Pull the blue tab and extend the cassette size mark.
  • Page 4 7 Even out the edges of the paper stack. Make sure the height of the stack does not exceed the limit marks the side edges of the stack are below the hooks (B). 9 Insert the tabs on the extension cover into the ➊...
  • Page 5: Connect The Power Cord

    Connect the power cord. Plug the power cord into the rear socket ➊. Then connect the other end to the wall outlet ➋. Once it is warmed up, the standby display appears in the LCD. IMPORTANT For important safety instructions on installation and handling of the machine, see “Important Safety ●...
  • Page 6: Install The Software

    Install the software. IMPORTANT Do not connect the USB cable before installing the software. If you connect the USB cable before installing the ● software and the Found New Hardware Wizard screen appears, click [Cancel] and disconnect the USB cable. Network Connection is not available for this model.
  • Page 7 When the installation is complete, click [Exit] to close the MF Drivers-Setup Wizard screen. On the MF Setup screen, click [Install MF Toolbox]. When the MF Toolbox-Setup Wizard screen appears, click [Next] and follow the instructions on the screen. NOTE Before installing MF Toolbox, make sure that all other ●...
  • Page 8 U.S.A. CUSTOMERS CANADA CUSTOMERS Part no. FA7-6515 (010) ©2005 Canon Inc. Canon and imageCLASS are trademarks of Canon Inc. All other products and brand names are registered trademarks or trademarks of their respective owners. Specifications subject to change without notice.