Table of Contents
Advertisement
Figure 49. Installing a drive carrier
Next steps
If removed,
install the front
Removing the drive from the drive carrier
Prerequisites
Follow the safety guidelines listed in
CAUTION:
Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1. Using a Phillips 1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE:
If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
remove the drive.
2. Lift the drive out of the drive carrier.
58
Installing and removing system components
bezel.
Safety
instructions.
- Quick Links:
- System Memory
Hide quick links:
Advertisement
Table of Contents
