Table of Contents
Advertisement
1. To remove the 2.5-inch drive backplane module. See "Remove the 2.5-inch drive backplane module" on
page 270.
2. Install a replacement unit. See "Install the 2.5-inch drive cage assembly" on page 269.
3. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the 2.5-inch drive cage assembly
Follow instructions in this section to install the 2.5-inch drive cage assembly.
About this task
Attention:
• Read "Installation Guidelines" on page 121 and "Safety inspection checklist" on page 122 to ensure that
you work safely.
• Touch the static-protective package that contains the drive to any unpainted metal surface on the server;
then, remove the drive from the package and place it on a static-protective surface.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku:
https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1.
Make sure the 2.5-inch drive backplane module is installed on the assembly. See "Install the 2.5-
inch drive backplane module" on page 271.
Step 2.
Place the 2.5-inch drive cage assembly in the chassis.
a.
Tilt the assembly so that its rear end is up; then, align the assembly with the upper inner
edge of the chassis, and lower it into the chassis.
b.
Place the rear end of the assembly onto the cross bar.
Figure 202. Placing the 2.5-inch drive cage assembly in the chassis
Cross bar
1
Step 3.
Installing the 2.5-inch drive cage assembly.
.
Chapter 4
Hardware replacement procedures
269
Advertisement
Table of Contents
