Table of Contents
Advertisement
3-4. Removing and Installing the Grille
Basically, these models can be installed and wired with-
out removing the grille. If access to any internal part is
needed, follow the steps as given below.
How to remove the grille
(1) Open the front panel until it is nearly horizontal, grasp
the sections near the front panel arms on both sides,
and then remove the panel by pushing the arms
towards the outside while pulling the panel towards
you.
If the front panel is difficult to remove, grasp both
ends of it and lift it up slightly. Move it to the left and
disengage the left arm, then move it to the right and
disengage the right arm. (Fig. 16)
(2) Lift the anti-mold filter up slightly to disengage it from
the protrusions on the unit, and then pull downward
to remove the filter from the unit. (Fig. 16)
(3) Remove the 3 screws from the front of the unit and
remove the screw covers on the bottom surface. Then
remove the 2 screws. (Fig. 17)
(4) Remove the screw on the right side cover plate and
remove the cover. (Fig. 17a)
(5) Remove the lower flap by disengaging 4 pins of the
lower flap in order. (Figs. 17b and 17c)
(The flap is so flexible that it can be easily removed.)
(6) Lift up the grille in the direction shown by the arrow
and pull the grille towards you to remove it. (Fig. 17d)
How to replace the grille
(1) While aligning the top edge of the grille with the
frame, move the grille horizontally and insert the top
and bottom into the frame.
(2) Press the grille firmly with your hand to ensure no gap
exists between the frame and grille.
(3) Tighten the 6 screws. And fix the removed covers in
place.
(4) Grasp the sections near the front panel arms on both
sides, and hold the front panel so that it is nearly hori-
zontal. Push the arm shafts towards the outside so
that they come into contact with the top of the inden-
tations on the right and left sides of the air condition-
er. Then push firmly until the arm shafts click into
place. (Fig. 18)
(5) Remount the lower flap.
(In remounting the flap, it cannot be turned end for
end because the right and left pins of the flap differ in
form. (Fig. 17c))
(6) Insert the top of the anti-mold filter, and then secure
the bottom of the filter with the protrusions on the unit.
(7) When closing the front panel, push the central part of
the front panel first and then press the bottom right
and left corners in place until you feel a click. (Fig. 19)
NOTE
Check that no gap exists between the frame and the
grille.
Front panel
Anti-mold filter
Screw (on the front)
Screw (on the bottom)
Screw cover
Grille
Upper flap
Lower flap
Fig. 17b
Front panel
14
Arm
Protrusions
Fig. 16
Grille
Screw (on the cover)
Screw
Bottom surface
Fig. 17a
Pin
Fig. 17c
Lower flap
Fig. 17d
Indentation
Arm
Pin
Fig. 18
Fig. 19
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
