Table of Contents
Advertisement
Figure 45. Installing the drive backplane cover
Next steps
1. Follow the procedure listed in
Control panel
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
Remove the air
Steps
1. Disconnect the right control panel cable from the connector on the system board.
2. Press and pull the latch to slide the cable out of the clip.
NOTE:
Observe the routing of the cable as you remove the right control panel from the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel to the system.
4. Holding the cable, slide the right control panel out of the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
instructions.
Before working inside your
cover.
shroud.
system..
system.
Installing and removing system components
79
Advertisement
Table of Contents
