Setting Up the Label Printer
Loading the DK Roll
a
Make sure that the label printer is turned Off.
Hold the printer by the front, and firmly lift the DK Roll Compartment Cover to open it.
b
Place the DK Roll into the Roll Spool Guide.
• Make sure that the Roll Spool Arm is inserted firmly in the Roll Spool Guide.
• Make sure the Stabiliser (1) slides into the notch of the printer.
• Make sure the [Paper Type] (Windows) / [Print Media] (Mac) in P-touch Editor matches the installed
media.
c
Thread the DK Roll through the printer.
• Align the edge of the DK Roll with the upright edge of the Label Output Slot.
• Insert the first label into the slot inside the compartment.
• Push the label through the Label Output Slot until the end reaches the mark, as shown below.
1
1
1
5