hit counter script

Cisco Nexus 9504 Hardware Installation Manual page 85

Aci-mode switch
Hide thumbs Also See for Nexus 9504:
Table of Contents

Advertisement

Replacing or Installing Modules, Fan Trays, and Power Supplies
1
2. Unscrew the two nuts holding each of the four cables to the terminal box. Remove the cables and replace the nuts
on the two posts in each of the slots.
3. Replace the safety cover on the terminal box and secure it in place with three screws.
c) Remove the power supply from the chassis as follows:
1. Slide the middle of the ejector lever toward the end of the lever and rotate the lever away from the chassis.
The power supply unlocks from the chassis and moves out slightly.
2. Use one of your hands to hold the front of the power supply and place your other hand under the power supply
to support its weight.
3. Pull the module out of the slot and place it on an antistatic surface or inside an antistatic bag.
Step 4
If you are not installing a replacement power supply, cover the empty power supply slot with a blank module.
Step 5
If you are installing a replacement power supply, install, connect, and power up the new power supply as follows:
a) Install the power supply as follows:
1. Hold the front of the power supply with one hand and place your other hand under the module to support its
weight.
2. Hold the power supply flat with the release lever on the upper left front end of the module. Position and orient
the other end of the module at the open power supply slot in the chassis.
Remove 3 screws from the
safety cover.
Cisco Nexus 9504 ACI-Mode Switch Hardware Installation Guide
Installing or Replacing a 3-kW DC Power Supply
2
Remove the cover.
75

Advertisement

Table of Contents
loading

Table of Contents