Table of Contents
Advertisement
Removing the system board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
NOTE: Your computer's Service Tag is stored in the system board. You must
enter the Service Tag in the BIOS setup program after you replace the
system board.
NOTE: Replacing the system board removes any changes you have made to
the BIOS using the BIOS setup program. You must make the appropriate
changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the
location of the connectors so that you can reconnect the cables correctly
after you replace the system board.
Prerequisites
1
Remove the
base
2
Remove the battery.
3
Remove the
solid-state drive/Intel
4
Remove the
memory
5
Remove the
heat
6
Remove the
power-adapter
Procedure
1
Disconnect the fan cable from the system board.
2
Peel off the tapes that secure the display cable and touch-screen board cable to
the system board.
3
Open the latches and disconnect the display cable and the touch-screen board
cable from the system board.
computer. After working inside your computer, follow
After working inside your
cover.
Optane.
modules.
sink.
port.
computer. For more safety best
www.dell.com/
Before
61
Advertisement
Table of Contents
