hit counter script

Installing The Storage Tray For Nvidia Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

Table of Contents

Advertisement

Installing the storage tray for NVIDIA GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the cable
cover.
4. Observe and disconnect the intrusion switch bridge cable from the connectors on the storage tray that is connected from
the system board. Observe and disconnect the drive backplane cables, BOSS power and signal cables, fan board cables from
the connector on the storage tray, signal cable from the connectors on the PDB2 and then keep the cables away from the
storage tray. Disconnect the VSB power cables (left and Right) from the connector on the system board and keep them on
the storage tray.
Steps
1. Align and insert the storage tray on the guiding slots of the chassis.
2. For tray installation, press down the handle and slide the tray into the chassis toward the rear of the system until it is firmly
seated.
3. Using a Phillips 1 screwdriver, tighten the screws on the drive cage.
NOTE:
There is label to show the Storage tray lock and unlock on the left side of the chassis.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 70. Installing the storage tray
Next steps
1. Reconnect the intrusion switch bridge cable from the storage tray that is connected from the system board. Reconnect the
drive backplane cables, BOSS power and signal cables, signal cable on the PDB2, fan board cables on the connector of the
storage tray. Reconnect the VSB power cables on the system board.
2.
Install the cable
cover.
102
Installing and removing system components
Safety
instructions.
Before working inside your
system.

Advertisement

Table of Contents
loading

This manual is also suitable for:

E100s

Table of Contents