Table of Contents
Advertisement
Figure 155. Lock the four blue plungers
Next steps
1. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
2.
Install the lower brace
3. Reconnect all the cables onto the system board. For more information, see
4.
Install the
Risers.
5.
Install the Storage tray
6.
Install the VSB cables on the system
7. Follow the procedure listed in the
.
LOM card and rear I/O board
Removing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) card and rear I/O board to
the system board.
2. Holding the edges, pull the LOM card or rear I/O board to disconnect from the connector on the system board.
170
Installing and removing system components
cover.
.
board.
After working inside your
Safety
Before working inside your
system.
instructions.
system.
Cabling
diagram.
Advertisement
Table of Contents
