Table of Contents
Advertisement
Figure 21. Cable routing - 4 x 3.5-inch cabled SAS drive with storage controller card
Table 11. Connector descriptions for 4 x3.5-inch cabled SAS drive with storage controller card
From
ODD (Optical disc drive connector)
ODD_PWR + HDD0, HDD1, HDD2, HDD3 (Optical disc drive
power connector, connecting through the drives 0, 1, 2, 3)
HDD0, HDD1, HDD2, HDD3 (Signal connector connecting
through the drives 0, 1, 2, 3)
Optional optical drive
This is a service technician replaceable part only.
Removing the optical drive fillers
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the front
bezel.
NOTE:
There are two optical drive fillers, plastic filler on the front bezel, and metal filler on the optical drive cage.
Steps
1. On the front bezel, press the retention clip of the optical drive filler and pull the filler from the front bezel.
Safety
instructions.
Before working inside your
To
SATA_ODD (Optical disc drive SATA connector on system
board)
HDD/ODD_PWR (Drives/Optical disc drive power connector
on the system board)
PERC (SAS connector of PERC card on the system board)
system.
Installing and removing system components
35
Advertisement
Table of Contents
