Table of Contents
Advertisement
Steps
1. Open the latch and disconnect the touchpad FFC from the connector on the system board.
2. Remove the three screws (M2x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
3. Lift the touchpad bracket off the touchpad assembly.
4. Remove the two screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
5. Lift the touchpad, along with the touchpad FFC, off the palm-rest and keyboard assembly.
6. Open the latch and disconnect the touchpad FFC from the connector on the touchpad.
Installing the touchpad
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Ensure that the touchpad is aligned with the guides available on the palm-rest and keyboard assembly, and the gap
on either sides of the touchpad is equal.
The following images indicate the location of the touchpad and provide a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
67
Advertisement
Table of Contents
