Installing The Touchpad - Dell Precision 3591 Owner's Manual
Hide thumbs
Also See for Precision 3591:
- Service manual (90 pages) ,
- Technical manualbook (50 pages) ,
- Setup and specifications manual (31 pages)
Table of Contents
Advertisement
6. Remove the
wireless
card.
7. Remove the
assembly-inner
About this task
The following images indicate the location of the touchpad and provide a visual representation of the removal procedure.
Figure 45. Removing the touchpad
Steps
1. Open the latch and disconnect the touchpad cable from the touchpad cable connector (TPAD1) on the system board.
2. Open the latch and disconnect the keyboard cable from the connector on the touchpad.
3. Peel the keyboard cable from the touchpad.
4. Open the latch and disconnect the keyboard-backlight cable from the connector on the touchpad.
5. Remove the five screws (M2x2.5) that secure the touchpad to the palm-rest assembly.
6. Lift up the flap below the touchpad cable and remove the screw (M2x2.5) that secures the touchpad to the palm-rest
assembly.
7. Lift the touchpad off the palm-rest assembly.
Installing the touchpad
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the touchpad and provide a visual representation of the installation procedure.
frame.
Removing and installing Field Replaceable Units (FRUs)
83
Advertisement
Table of Contents
