Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the installation
procedure.
Figure 51. Installing the coin-cell battery
Steps
1. Adhere the coin-cell battery on to the coin-cell battery slot on the palm-rest assembly.
2. Route the coin-cell battery cable through the routing guides on the palm-rest assembly.
3. Connect the coin-cell battery cable to the coin-cell battery cable connector (RTC1) on the system board.
Next steps
1. Install the battery.
2. Install the
assembly-inner
3. Install the
plastic
filler, if applicable.
4. Install the
base
cover.
5. Install the
SIM
card.
6. Follow the procedure in
Fan and heat-sink assembly
Removing the fan and heat-sink assembly (Discrete GPU)
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
88
Removing and installing Field Replaceable Units (FRUs)
frame.
After working inside your
Before working inside your
computer.
computer.