Table of Contents
Advertisement
Figure 73. Installing the internal speaker
Steps
1. Align the holes on the internal speaker with the alignment post on the chassis.
2. Insert the internal speaker into its slot.
3. Route the internal speaker cable through the recess on the front of the chassis.
4. Connect the internal speaker cable to the connector on the system board.
Next steps
1. Install the
air
shroud.
NOTE:
For systems with 500W/1000W PSU only.
2. Install the
side
cover.
3. Follow the procedure in
System board
Removing the system board
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE:
Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. You must make the appropriate changes again after you replace the system board.
NOTE:
Before disconnecting the cables from the system board, note the location of the connectors so that you can
reconnect the cables correctly after you replace the system board.
2. Remove the
side
cover.
after working inside your
before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
101
Hide quick links:
Advertisement
Table of Contents
