Table of Contents
Advertisement
Figure 41. Installing the processor
Steps
1. Ensure that the release lever on the processor socket is fully extended in the open position.
NOTE:
The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor
socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of
the processor are higher than the others, the processor is not seated properly.
2. Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket.
CAUTION:
Ensure that the processor-cover notch is positioned underneath the alignment post.
3. When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor
cover.
Next steps
1. Install the
heat
sink.
2. Install the
processor
fan.
3. Install the
side
cover.
4. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
memory
modules.
4. Remove the
riser-card
5. Remove the
M.2 2230 SSD (slot-1)
6. Remove the
M.2 2280 SSD (slot-1)
7. Remove the
wireless
card.
8. Remove the
coin-cell
9. Remove the speaker.
after working inside your
before working inside your
module.
or
M.2 2230 SSD
or
M.2 2280 SSD
battery.
computer.
computer.
(slot-2).
(slot-2).
Removing and installing Field Replaceable Units (FRUs)
75
Advertisement
Table of Contents
