Table of Contents
Advertisement
Figure 84. Installing the speaker
Steps
1. Route the speaker cable through the slot on the chassis.
2. Press the tabs on the speaker and push the speaker into the slot on the chassis until it snaps into place.
3. Connect the speaker cable to the speaker dongle cable.
4. Route the speaker-dongle cable through the routing guide on the intrusion switch.
5. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the
air
shroud.
2. Install the
front
bezel.
3. Install the
side
cover.
4. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following image indicates the location of the coin-cell battery and provide a visual representation of the removal procedure.
112
Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
