Cisco Nexus 3048 Switch
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 1-4
1
2
Ports for the Cisco Nexus 3048 Switch
The Cisco Nexus 3048 switch chassis includes the following ports:
•
•
•
•
•
The chassis has 48 10/100/1000 Ethernet downlink ports that you connect to servers, which are often in
the same rack or a nearby rack. You use RJ-45 connectors with copper cables to connect the switch to
the servers. The ports are numbered from left to right from 1 to 48 with the odd-numbered ports on top
and the even-numbered ports on the bottom.
You use up to four 1- and 10-Gigabit Ethernet uplink ports to connect the switch to one to four hosts or
switches. You use an SFP or SFP+ transceiver for each of these ports.
Two 100/1000 Ethernet management ports enable you to manage switch operations. You can connect to
the switch through these two ports by using an RJ-45 connector on a copper cable.
One console port enables you to initially configure the switch and to perform troubleshooting operations.
You use an RJ-45 connector with a copper cable to connect to this port.
One USB port enables you to save or load switch configurations.
Cisco Nexus 3000 Series Hardware Installation Guide
1-8
Rear View of the Cisco Nexus 3048 Switch
ID and Status LEDs
10/100/1000 Ethernet downlink ports (48)
10/100/1000 Ethernet downlink ports (48 ports)
1- and 10-Gigabit Ethernet uplink ports
100/1000 Ethernet management ports (2 ports)
Console port (1 port)
USB port (1 port)
Chapter 1
Overview of the Cisco Nexus 3000 Series Switches
3
1- and 10-Gigabit Ethernet uplink ports (4)
4
Grounding pad
OL-25338-04