Removing The System Battery - Dell PowerEdge T100 Series Hardware Owner's Manual
Hide thumbs
Also See for PowerEdge T100 Series:
- Getting started with (62 pages) ,
- Update manual (14 pages) ,
- Feature (2 pages)
Table of Contents
Advertisement
You can operate your system without a battery; however, without a battery, the
configuration information is erased if the system is turned off or unplugged
from the electrical outlet. In this case, you must enter the System Setup
program and reset the configuration options.
CAUTION:
battery only with the same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer's instructions.
Removing the System Battery
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Enter the System Setup program and record the option settings on the
System Setup screens. See "Using the System Setup Program" on page 29.
2 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
3 Open the system. See "Opening the System" on page 47.
4 See Figure 6-2 for the location of the system battery and then remove any
cables that block access to the battery.
5 Grasp the battery with your fingers and pull it out of the battery socket.
See Figure 3-26.
90
Installing System Components
A new battery can explode if it is incorrectly installed. Replace the
Many repairs may only be done by a certified service technician. You
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
