Canon iPF8400S User Manual page 631
Hide thumbs
Also See for iPF8400S:
- Service manual (312 pages) ,
- Basic manual (160 pages) ,
- Setup manual (16 pages)
Table of Contents
Advertisement
iPF8400S
To use the ARP and PING commands, you will need to know the printer's MAC address. You can confirm the MAC
address on the Control Panel.
1
Check the printer's MAC address.
You can confirm the MAC address on the Control Panel as follows:
1.
On the Tab Selection screen of the Control Panel, press ◀ or
▶ to select the Settings/Adj. tab (
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.
5.
Press ▲ or ▼ to select MAC Address, and then press the OK button.
•
If the Tab Selection screen is not displayed, press the Menu button.
You can investigate the MAC address by printing an interface setting report.
Note
•
(See "Printing Interface Setting Reports.")
2
In Windows, open a command prompt, or in Mac OS X, start Terminal.
3
Execute the following command to add entries to the ARP table for managing IP addresses and corre-
sponding MAC addresses.
arp -s [IP address] [the printer's MAC address you have verified]
Example: arp -s xxx.xxx.xxx.xxx xx-xx-xx-xx-xx-xx
•
In Mac OS X when using Terminal, enter the arp command in the format
arp -s xxx.xxx.xxx.xxx xx-xx-xx-xx-xx-xx.
Note
For details, refer to the help file for the command line.
4
Execute the following command to send the IP address to the printer and configure it.
ping [IP address as specified in the ARP command] -l 479
Example: ping xxx.xxx.xxx.xxx -l 479
In -l, the l is the letter l.
•
Note
•
In Mac OS X when using Terminal, enter the ping command in the format
ping -s 479 xxx.xxx.xxx.xxx.
For details, refer to the help file for the command line.
•
The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and default gateway
to match your network settings.
Note
For details on RemoteUI, see "Using RemoteUI."
User's Guide
Configuring the IP Address Using ARP and PING Commands
).
P.603
➔
P.627
➔
631
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
