Paprwidth Mismatch; Paper Size Not Detected - Canon iPF8400S User Manual
Hide thumbs
Also See for iPF8400S:
- Service manual (312 pages) ,
- Basic manual (160 pages) ,
- Setup manual (16 pages)
Table of Contents
Advertisement
PaprWidth Mismatch
"Replace roll with 10 in. wide or larger roll."
The loaded paper is too small.
(When you have attempted to print a test print sheet or other
printer status information.)
PaprWidth Mismatch
PaprWidth Mismatch
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver.
Paper size not detected.
Paper size not detected.
Paper has been loaded askew, or warped paper has been loaded.
886
Because the Platen is soiled with ink or other substances, the size of the clear film can-
not be detected.
Cause
Cause
Cause
Replace the roll with a roll 10 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Corrective Action
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace with paper of the width configured in the printer driver.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Lift up the Release Lever and reload the pa-
per.
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Print-
er.")
If "Not finished printing. Finish printing re-
maining jobs?" is displayed on the Display
Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push
the roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Attaching the Roll Holder to
Rolls.")
Open the Top Cover and clean the entire
Platen.
(See "Cleaning Inside the Top Cov-
er.")
Corrective Action
P.477
➔
P.479
➔
P.469
➔
P.471
➔
P.477
➔
P.479
➔
P.469
➔
P.471
➔
Corrective Action
P.492
➔
P.469
➔
P.840
➔
iPF8400S
P.471
➔
User's Guide
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
