Rf Manual Tuning Guide; Required Manual Tunings After Component Changes - Nokia n80 User Manual
Hide thumbs
Also See for n80:
- User manual (142 pages) ,
- Manual (128 pages) ,
- Aplicaciones adicionales manual (33 pages)
Table of Contents
Advertisement
Nokia Customer Care
RF manual tuning guide
Required manual tunings after component changes
Important:
in rare cases.
If, however, manual tuning is used, only relevant tunings should be performed. Refer to the following table:
Changed component
RF ASIC N7500 (RM-92) or N7505 (RM-91)
Any component in the GSM TX RF chain before the
PA
Any component in the GSM TX RF chain after the PA
or PA
Any component in the WCDMA TX RF chain before
the PA
Any component in the WCDMA TX RX chain after the
PA, PA, power detector or PA switch mode power
supply
Any component in the GSM RX chain
Any component in the WCDMA RX chain
VCTCXO G7501 (RM-91) G7500 (RM-92)
WLAN Module (N5500)
Page 7 –28
After RF component changes, always use autotuning. Manual tunings are only required
COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
RF Troubleshooting and Manual Tuning Guide
Perform the following tunings
RF Channel Filter Calibration, Temperature Sensor
Calibration, Rx calibration (GSM), Rx band filter
response compensation (GSM), TxIQ Tuning (GSM),
Tx Power Level Tuning (GSM), Rx calibration
(WCDMA), Tx AGC & Power Detector (WCDMA), Tx
Band Response Calibration (WCDMA), Tx LO Leakage
(WCDMA)
Tx IQ Tuning, Tx Power Level Tuning
Tx Power Level Tuning
Tx AGC & Power Detector, Tx Band Response
Calibration, Tx LO Leakage
Tx AGC & Power Detector, Tx Band Response
Calibration, PA Detection
Rx Calibration, RX Band Filter Response
Compensation
Rx AGC Alignment, RX Band Response Calibration
Rx Calibration (GSM900 band)
WLAN Tx Tuning
RM-91; RM-92
Issue 1
Advertisement
Chapters
Table of Contents
Troubleshooting
