hit counter script

Replacing A Hard Drive - Dell Studio XPS 435 MT Service Manual

Table of Contents

Advertisement

Back to Contents Page
  Replacing Drives
Dell Studio XPS™ 435MT Service Manual 
  Replacing a Hard Drive
  Replacing an Optical Drive
  Replacing the FlexDock
  Removing the FlexDock Break-Away Metal Plate
  Replacing the FlexDock Drive Inserts
  Replacing the Drive Panel Insert
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
The system board does not support IDE devices.
NOTE:
The 3.5-inch FlexDock is not interchangeable with the hard drive carrier.
 Replacing a Hard Drive
 
CAUTION:
If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.
 
1. Follow the procedures in
Before You
 
2. Remove the computer cover (see
 
3. Disconnect the power and data cables from the hard drive.
NOTE:
If you are not replacing the hard drive at this time, disconnect the other end of the data cable from the system board and set it aside. You
can use the data cable to install a hard drive at a later time.
1 screws
2 system board connector (any available connector SATA0,
(4)
SATA1, SATA2, and SATA3)
3 data
4 power cable
cable
5 hard
 
 
drive
 
4. Remove the four screws securing the hard drive to the chassis.
 
CAUTION:
Ensure that you do not scratch the hard disk's circuit board, while removing or replacing the hard drive.
 
5. Slide the drive out towards the back of the computer.
 
6. To replace the hard drive, check the documentation for the drive to verify that it is configured for your computer.
 
7. Slide the hard drive into the hard drive bay.
 
Begin.
Replacing the Computer
Cover).

Advertisement

Table of Contents
loading

Table of Contents