Enabling Ethernet Oam On An Interface - Cisco Catalyst 4500 Series Configuration Manual
Release ios xe 3.3.0sg and ios 15.1(1)sg
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1254 pages)
Table of Contents
Advertisement
Enabling and Configuring Ethernet OAM
Enabling Ethernet OAM on an Interface
To enable Ethernet OAM on an interface, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# interface interface-id
Step 3
Switch(config-if)# ethernet oam
Step 4
Switch(config-if)# ethernet oam [max-rate
|
oampdus
min-rate seconds
|
passive}
timeout seconds]
Step 5
Switch(config-if)# end
Step 6
Switch# show ethernet oam status [interface
]
interface-id
Step 7
Switch# copy running-config startup-config
Enter the no ethernet oam interface configuration command to disable Ethernet OAM on the interface.
This example shows how to set basic OAM parameters on the switch:
Switch(config)# int gi1/3
Switch(config-if)# ethernet oam
Switch(config-if)# ethernet oam max-rate 9
Switch(config-if)# ethernet oam mode passive
Switch(config-if)# end
Switch# show ethernet oam status int gi1/2
GigabitEthernet1/2
General
-------
Admin state:
Mode:
PDU max rate:
PDU min rate:
Link timeout:
High threshold action: no action
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
63-36
Purpose
Enters global configuration mode.
Defines an interface to configure as an EOM interface, and
enters interface configuration mode.
Enables Ethernet OAM on the interface.
Configures these optional OAM parameters:
|
|
mode {active
Note
Returns to privileged EXEC mode.
Verifies the configuration.
(Optional) Saves your entries in the configuration file.
enabled
passive
9 packets per second
1 packet per 1 second
5 seconds
Chapter 63
(Optional) Enter max-rate oampdus to configure the
•
maximum number of OAM PDUs sent per second. The
range is from 1 to 10.
•
(Optional) Enter min-rate seconds to configure the
minimum transmission rate in seconds when one OAM
PDU is sent per second. The range is from 1 to 10.
•
(Optional) Enter mode active to set OAM client mode
to active. active is the default.
•
(Optional) Enter mode passive to set OAM client
mode to passive.
When Ethernet OAM mode is enabled on two
interfaces passing traffic, at least one must be in the
active mode.
(Optional) Enter timeout seconds to set a time for
•
OAM client timeout. The range is from 2 to 30.
Configuring Ethernet OAM and CFM
OL-25340-01
- Quick Links:
- Resetting a Switch to Factory Default...
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
