Table of Contents
Advertisement
After Replacing the ADF CIS Unit
NOTE:
Location where the service label is affixed
The service label is affixed on the Main Controller Cover on the left side of the host machine.
1. Automatic adjustment of the stream reading position
1. Entering a provisional value
• In COPIER > ADJUST > ADJ-XY > STRD-POS , set the value to "-20".
2. Executing the service mode
Execute the following service mode.
• COPIER > FUNCTION > INSTALL > STRD-POS
CAUTION:
Be sure to close the ADF before executing the foregoing service mode. Also be sure not to open the ADF while the service
mode is being executed.
3. If OK or NG is displayed on the UI, whether the operation was successful or failed can be judged based on it. If OK or
NG is not displayed, check the following value.
• COPIER > ADJUST > ADJ-XY > STRD-POS
If the value above is -20 and remains unchanged, it is judged that the operation failed.
4. In the case of a failure, turn OFF and then ON the power of the host machine, and execute the following service mode
again.
• COPIER > FUNCTION > INSTALL > STRD-POS
5. If the operation is successful
Write the following value on the service label.
• COPIER > ADJUST > ADJ-XY > STRD-POS
2. AGC adjustment (back side) (duplex scanning ADF model only)
1. Entering a provisional value
Change the values of the following service mode settings to 1,000.
• COPIER > ADJUST > CCD > LE-BWRBK
• COPIER > ADJUST > CCD > LE-BWGBK
• COPIER > ADJUST > CCD > LE-BWBBK
Change the values of the following service mode settings to 1,100.
• COPIER > ADJUST > CCD > LE-CLRBK
• COPIER > ADJUST > CCD > LE-CLGBK
• COPIER > ADJUST > CCD > LE-CLBBK
198
6. Adjustment
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
