Chapter 49
Troubleshooting
Step 6
Initialize the flash file system:
switch: flash_init
Connect the switch to a TFTP server through the Ethernet management port.
Step 7
Start the file transfer by using TFTP.
Step 8
a.
b.
Copy the software image from the TFTP server to the switch:
Step 9
switch: copy tftp:// ip_address / filesystem :/ source-file-url flash: image_filename.bin
Boot up the newly downloaded Cisco IOS image.
Step 10
switch: boot flash: image_filename.bin
Step 11
Use the archive download-sw privileged EXEC command to download the software image to the switch
or to the switch stack.
Use the reload privileged EXEC command to restart the switch and to verify that the new software image
Step 12
is operating properly.
Delete the flash:image_filename.bin file from the switch.
Step 13
Recovering from a Lost or Forgotten Password
The default configuration for the switch allows an end user with physical access to the switch to recover
from a lost password by interrupting the boot process during power-on and by entering a new password.
These recovery procedures require that you have physical access to the switch.
On these switches, a system administrator can disable some of the functionality of this feature by
Note
allowing an end user to reset a password only by agreeing to return to the default configuration. If you
are an end user trying to reset a password when password recovery has been disabled, a status message
shows this during the recovery process.
These sections describes how to recover a forgotten or lost switch password:
•
•
You enable or disable password recovery by using the service password-recovery global configuration
command. When you enter the service password-recovery or no service password-recovery command
on the stack master, it is propagated throughout the stack and applied to all switches in the stack.
Follow the steps in this procedure if you have forgotten or lost the switch password.
Use one of these methods to connect a terminal or PC to the switch:
Step 1
OL-9775-08
Specify the IP address of the TFTP server:
switch: set ip_addr ip_address/mask
Specify the default router:
switch: set default_router ip_address
Procedure with Password Recovery Enabled, page 49-4
Procedure with Password Recovery Disabled, page 49-6
Recovering from a Lost or Forgotten Password
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
49-3