Replacing Blower And Heat-Sink Assembly - Dell XPS 8930 Service Manual
Hide thumbs
Also See for XPS 8930:
- Setup and specifications (29 pages) ,
- Service manual (111 pages) ,
- Setup and speci?cations (13 pages)
Table of Contents
Advertisement
Replacing blower and heat-sink
assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
CAUTION: If either the processor or the heat-sink assembly is replaced, use
the thermal grease provided in the kit to make sure that thermal
conductivity is achieved.
NOTE: The original thermal grease can be reused if the original processor
and heat-sink assembly are reinstalled together.
1
Connect the blower cable to the system board.
For more information, see
2
Place the heat-sink assembly over the processor.
3
Align the captive screws on the heat-sink assembly with the screw holes on the
system board.
4
In a non-adjacent sequence, tighten the captive screws that secure the heat-sink
assembly to the system board.
5
Place the blower over the heat-sink assembly.
6
Align the screw holes on the blower to the screw holes on the heat-sink
assembly.
7
Replace the screws that secure the blower to the heat-sink assembly.
Post-requisites
1
Follow the procedure from step 9 to step 10 in
unit".
88
computer. After working inside your computer, follow
After working inside your
"System-board
computer. For more safety best
components".
"Replacing the power-supply
Before
www.dell.com/
Hide quick links:
Advertisement
Table of Contents
