Assigning Mac-Based Vlan Groups; Gvrp Settings - Cisco SF 300-08 Administration Manual
Cisco small business 300 series managed switch
Hide thumbs
Also See for SF 300-08:
- Quick start manual (72 pages) ,
- Datasheet (14 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
VLAN Management
VLAN GROUPS
STEP 4
STEP 5
STEP 6
STEP 7
VLAN GROUPS
Cisco Small Business 300 Series Managed Switch Administration Guide
Select an interface type (Port or LAG), and click Go. The following fields are
displayed in the GVRP Setting Table.
•
Interface—Port or LAG number.
•
GVRP State—Displays whether GVRP is enabled/disabled on the interface.
•
Dynamic VLAN Creation—Displays whether Dynamic VLAN creation is
enabled/disabled on the interface. If it is disabled, GVRP can operate but
new VLANs are not created.
•
GVRP Registration—Displays whether VLAN registration through GVRP is
enabled/disabled on the port.
To define GVRP settings for a port, select it, and click Edit. The
Page
opens.
Enter the values for the following fields:
•
Interface—Select the interface (Port or LAG) to be edited.
•
GVRP State—Select to enable GVRP on this interface.
•
Dynamic VLAN Creation—Select to enable Dynamic VLAN Creation on this
interface.
•
GVRP Registration—Select to enable VLAN Registration using GVRP on
this interface.
Click Apply. GVRP settings are modified, and the switch is updated.
Assigning MAC-based VLAN Groups
Use this feature to assign untagged traffic from specific MAC addresses to a
specific VLAN for devices in Layer 2 mode. This assignment is performed in
stages:
1. Assign the MAC address to a Group ID (an identifier created by using the
Based Groups Page
2. For each interface, assign the VLAN group to a VLAN by using
to VLAN Page
. (The interfaces must be in General mode.)
).
11
Edit GVRP Setting
MAC
Mapping Group
119
Hide quick links:
Advertisement
Table of Contents
