Configuring Control Plane Policing
4. (Optional) show policy-map interface control-plane
5. (Optional) copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
control-plane
Example:
switch(config)# control-plane
switch(config-cp)#
Step 3
scale-factor value module multiple-module-range
Example:
switch(config-cp)# scale-factor 1.10 module 1-2
Step 4
(Optional) show policy-map interface control-plane
Example:
switch(config-cp)# show policy-map interface
control-plane
Step 5
(Optional) copy running-config startup-config
Example:
switch(config)# copy running-config startup-config
Changing or Reapplying the Default CoPP Policy
You can change to a different default CoPP policy, or you can reapply the same default CoPP policy.
SUMMARY STEPS
1. [no] copp profile [strict | moderate | lenient | dense]
2. (Optional) show copp status
3. (Optional) show running-config copp
Purpose
Enters global configuration mode.
Enters control plane configuration mode.
Configures the policer rate per line card. The allowed scale
factor value is from 0.10 to 2.00. When the scale factor
value is configured, the policing values are multiplied by
the corresponding scale factor value of the module, and it
is programmed in the particular module.
To revert to the default scale factor value of 1.00, use the
no scale-factor value module multiple-module-range
command, or explicitly set the default scale factor value to
1.00 using the scale-factor 1 module
multiple-module-range command.
Displays the applied scale factor values when a CoPP policy
is applied.
Copies the running configuration to the startup
configuration.
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
Changing or Reapplying the Default CoPP Policy
479